2001 V70 Brake Rotors

Discussion in 'Volvo V70' started by Guest, May 27, 2007.

  1. Guest

    Guest Guest

    I'm replacing the front brakes on a 2001 V70. Got the calipers,
    brackets, pads and small 6mm bolt out. There is nothing else obviously
    holding the rotor on except rust (!), and that's currently soaking in PB
    Blaster. Before I go back (after finishing this beer) to tap on it
    again with the copper hammer, I thought I'd check and see if there's
    anything unobvious I need to remove first...

    TIA...
     
    Guest, May 27, 2007
    #1
  2. Guest

    Roger Mills Guest

    In an earlier contribution to this discussion,
    No, there's nothing else holding it. It's just binding on the hub spigot.
    --
    Cheers,
    Roger
    ______
    Email address maintained for newsgroup use only, and not regularly
    monitored.. Messages sent to it may not be read for several weeks.
    PLEASE REPLY TO NEWSGROUP!
     
    Roger Mills, May 28, 2007
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. factory vs. aftermarket brake rotors ('92 240)

  2. aftermarket brake rotors any good? '92 240

  3. I will use aftermarket brake rotors unless...

  4. Who makes Volvo's Rotors and Brake Pads?

  5. Brake Rotors on 940

  6. Gotta replace brake rotors and pads at the same time (99 V70 AWD)?

Loading...