R
Ron
I recently had my 89 740 8V non turbo serviced, i.e. (tune up) at that
time my mechanic informed me that the AMM was bad in my car because i
was having a hard time getting the thing to start and when it would
start it would die so the starting process could take 2-4 minutes for it
finally to start and stay running ( hot or cold weather usually first
start of day or after sitting for 3 or 4 hr.). He checked the fuel
check valve it was fine, but he found that if you disconnected the AMM
it would fire right up then let it idle for around 30 seconds and replug
in the AMM it would continue to idle and warm to running temp then it
was fine to drive. It does however tend to hesitate from a stop when
taking off (almost like bogging down like a old carburetor. car with a
large fuel dump). then accelerate fine.
I bought this car 5 months and has always started hard it is the same as
when I bought it. A couple of days ago my son tried to start the car
without doing the AMM trick it started and died a couple times then
nothing for days would only crank not start AMM plugged in or not. I
checked and replaced the fuel relay, replaced a bad fuel pump fuse.
Confirmed that the tank pump worked and the main fuel pump worked.
Confirmed fuel to the fuel injector bar, took spare plug using #1 wire
confirmed by holding threads next to the block I had spark (spark seemed
small to me I no sure how intense it is to be but it did spark across
the plug gap). Still no start. Then I pulled the radio suppresser
relay on the water res. tank and reseated the connector I also unplugged
and reseated the RPM sensor a couple times, and tightened up the power
booster thing on the driver side inner fender wall ( it only has one
screw in it attaching it to the wall I need to find another) Unplugged
the AMM Bingo it started. Still hesitates slightly when
accelerating from a standing stop even when warm. I hesitant to drive
it because I not confident in its ability to routinely restart.
New Parts:
Alternator, timing belt, Fuel pump relay, engine block heat sensor,
plugs, RPM sensor papers to be replaced clean cable white band I did
not replace it in must have been replaced by privies owner. Idle control
value works and has been cleaned, throttle body cleaned, flame trap new.
Question :
Is the AMM bad? And if the AMM was bad wouldn't run like crap with the
thing plugged in not just have a starting problem?
If the AMM is not bad what's going on?
Thanks
Ron
time my mechanic informed me that the AMM was bad in my car because i
was having a hard time getting the thing to start and when it would
start it would die so the starting process could take 2-4 minutes for it
finally to start and stay running ( hot or cold weather usually first
start of day or after sitting for 3 or 4 hr.). He checked the fuel
check valve it was fine, but he found that if you disconnected the AMM
it would fire right up then let it idle for around 30 seconds and replug
in the AMM it would continue to idle and warm to running temp then it
was fine to drive. It does however tend to hesitate from a stop when
taking off (almost like bogging down like a old carburetor. car with a
large fuel dump). then accelerate fine.
I bought this car 5 months and has always started hard it is the same as
when I bought it. A couple of days ago my son tried to start the car
without doing the AMM trick it started and died a couple times then
nothing for days would only crank not start AMM plugged in or not. I
checked and replaced the fuel relay, replaced a bad fuel pump fuse.
Confirmed that the tank pump worked and the main fuel pump worked.
Confirmed fuel to the fuel injector bar, took spare plug using #1 wire
confirmed by holding threads next to the block I had spark (spark seemed
small to me I no sure how intense it is to be but it did spark across
the plug gap). Still no start. Then I pulled the radio suppresser
relay on the water res. tank and reseated the connector I also unplugged
and reseated the RPM sensor a couple times, and tightened up the power
booster thing on the driver side inner fender wall ( it only has one
screw in it attaching it to the wall I need to find another) Unplugged
the AMM Bingo it started. Still hesitates slightly when
accelerating from a standing stop even when warm. I hesitant to drive
it because I not confident in its ability to routinely restart.
New Parts:
Alternator, timing belt, Fuel pump relay, engine block heat sensor,
plugs, RPM sensor papers to be replaced clean cable white band I did
not replace it in must have been replaced by privies owner. Idle control
value works and has been cleaned, throttle body cleaned, flame trap new.
Question :
Is the AMM bad? And if the AMM was bad wouldn't run like crap with the
thing plugged in not just have a starting problem?
If the AMM is not bad what's going on?
Thanks
Ron