85 240 Temp Gauge Sensor

  • Thread starter Thread starter madrone
  • Start date Start date
M

madrone

I recently had my temperature gauge fail, and tracked the problem down
to a bad wire on the sensor. I tried to splice a little farther up the
harness, but in the end I had to splice onto the wire next to the gray
connector at the firewall. Now I'm getting hesitation on cold
acceleration. Is the gauge sensor connected to the ecu temperature
sensor? Did I bypass some important wiring, or was it a coincidence?
 
madrone said:
I recently had my temperature gauge fail, and tracked the problem down
to a bad wire on the sensor. I tried to splice a little farther up the
harness, but in the end I had to splice onto the wire next to the gray
connector at the firewall. Now I'm getting hesitation on cold
acceleration. Is the gauge sensor connected to the ecu temperature
sensor? Did I bypass some important wiring, or was it a coincidence?
Click to expand...

No the gauge sensor is not connected to the ecu at all. But, the temp
sensor the ecu uses is right beside the gauge sensor, you probably
disturbed its wiring.

--
Mike F.
Thornhill (near Toronto), Ont.

Replace tt with t (twice!) and remove parentheses to email me directly.
(But I check the newsgroup more often than this email address.)
 
The wiring harness in and near the engine on these cars is a known weak
point, and crumbles and deteriorates after awhile.

If you plan to keep the car, and want to avoid problems: have a new one
installed, or buy a used one in good shape.

Dave Barton is reputed to be a good source of used harnesses, although
I found and removed one from a car (a recent, new OEM replacement) from
a wreck in a U Pull It.

You can replace it yourself (I did), but it isn't easy and requires
some patience.

link to Dave Barton...

http://www.bartonharness.com/volvoharnesses.html
 
Thanks!

I'm dreading the inevitable harness replacement. I might just look for
a nice '88 with a 5 speed...

I solved my hesitation problem with a good cleaning of the cap and
rotor, so I'll pretend the wiring's ok for now.
 
The problem with your idea of looking for a nice 88 is that the wiring
could well be shot on it, too.

It is endemic: over time, it will happen.

A bad harness can cause myriad problems, often intermittent and hard to
troubleshoot.

The hardest thing about doing a wiring replacement is getting acces to
everything; you'll need to remove the intake manifold; if you are
comfortable in doing that, and have the time, you can do it.
 
Mr. V said:
The problem with your idea of looking for a nice 88 is that the wiring
could well be shot on it, too.

It is endemic: over time, it will happen.

A bad harness can cause myriad problems, often intermittent and hard to
troubleshoot.

The hardest thing about doing a wiring replacement is getting acces to
everything; you'll need to remove the intake manifold; if you are
comfortable in doing that, and have the time, you can do it.
Click to expand...


They changed the wiring in '88, or was it '89? The newer cars don't rot.
Still you can put an updated harness on an older car, or just rebuild
the old one.
 
James said:
They changed the wiring in '88, or was it '89? The newer cars don't rot.
Still you can put an updated harness on an older car, or just rebuild
the old one.
Click to expand...


Don't count on an '88 having the better wiring harness. Ours
didn't!
 
You must log in or register to reply here.
Back
Top