850 power seat control module connections

Discussion in 'Volvo 850' started by Joe landy, Jun 28, 2004.

  1. Joe landy

    Joe landy Guest

    Hi there hhatza.
    I went through all this with my V70 when I replaced the seats.
    I have a diagram of the connections, which I'll scan, and mail to you
    directly.
    I didn't have a proper plug connector for my seats, so I just used insulated
    faston crimps. My diagram therefore shows pin positions, not wire colours,
    but I'm sure you can work them out!
    I took power from the cigar lighter plug for the seat, and ran a small wire
    straight to the battery via 1A fuse for the memory facility (requires
    permanent 12V).
    If anyone else requires a copy, please ask me here. My E-mail server deletes
    all mail from people who aren't in my address book. It's a pity, but spam
    forced me to do this.
    Cheers.
    Joe.
     
    Joe landy, Jun 28, 2004
    #1
    1. Advertisements

  2. Joe landy

    hhatza Guest

    I replaced my old seats in my 850 SE with leather seats. The new seats have
    the power control module with the 3 memories.
    There are three wires that go to the unit, one black, one white and one
    red/green.
    Does anyone know the correct wiring for the control module? I need to wire
    them to my car, any recommendations will be much appreciated.
    Many thanks
     
    hhatza, Jun 28, 2004
    #2
    1. Advertisements

  3. I replaced my old seats in my 850 SE with leather seats. The new seats
    have
    Red / green is +12V.
    White doesnt need to be connected, its for faultreading through the OBD
    connecter, pin 7.
    Black is ground.

    Niels
     
    Niels Bengaard, Jun 28, 2004
    #3
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.