T
Tim C
Long story short, somehow the set screw for the power steering
pump* on my 940 (B230F) backed itself out and ran off. I've since
locked a position by hand, but when I make sharp turns (i.e. parking
lot) my dash goes nuts, and I have an awful belt squeal at low
RPM... which, fun though it may be for pedestrians, does drive
me nuts when I roll down the window.
I'm blessed to live in a city with scads of hardware stores but
not many junkyards. Does anyone know what the size of the screw
is so I can pick up/special order one? Is it the same size
as the screw for the alternator? For obvious reasons I'm most
concerned about length and shaft width.
Thanks in advance,
-TC
* Maybe not the power steering pump? It's below the alternator,
and links to the outermost belt on the shaft.
pump* on my 940 (B230F) backed itself out and ran off. I've since
locked a position by hand, but when I make sharp turns (i.e. parking
lot) my dash goes nuts, and I have an awful belt squeal at low
RPM... which, fun though it may be for pedestrians, does drive
me nuts when I roll down the window.
I'm blessed to live in a city with scads of hardware stores but
not many junkyards. Does anyone know what the size of the screw
is so I can pick up/special order one? Is it the same size
as the screw for the alternator? For obvious reasons I'm most
concerned about length and shaft width.
Thanks in advance,
-TC
* Maybe not the power steering pump? It's below the alternator,
and links to the outermost belt on the shaft.