240 fender type?

Discussion in 'Volvo 240' started by MonkeyMan, Jul 1, 2003.

  1. MonkeyMan

    MonkeyMan Guest

    I need to replace the driver side front fender on my '89 244DL.

    Are these fenders all the same from 1993 back to 1980?

    Thank you.
     
    MonkeyMan, Jul 1, 2003
    #1
    1. Advertisements

  2. MonkeyMan

    Dave Shannon Guest

    '86-'93, the previous years had different corner lights.
    Dave Shannon
    (Spring Valley CA)
    1988 240 DL 18X,XXX
    1985 240 Ti 20X,XXX
    1984 245 DL 20X,XXX
    1984 245T 19X,XXX
    '01 Jeep Wrangler Sahara 10K
    http://www.homestead.com/volvo2/
     
    Dave Shannon, Jul 2, 2003
    #2
    1. Advertisements

  3. MonkeyMan

    MonkeyMan Guest

    Dave, thanks.,

    Allan
    1989 240 DL 18xK
    1984 240Ti 19xK
     
    MonkeyMan, Jul 2, 2003
    #3
  4. And that one guy says old cars are hard to repair ;)

    Just pick any old big-light Volvo in the lot - 95% of the parts
    on the entire car match hole for hole, screw for screw.
     
    Joseph Oberlander, Jul 2, 2003
    #4
  5. MonkeyMan

    MonkeyMan Guest

    Thanks.

    How about sway bars?

    Frsom an '82 242 turbo to a 1989 244?
     
    MonkeyMan, Jul 2, 2003
    #5
  6. MonkeyMan

    Alex Zepeda Guest

    For the front, any 240 bar will fit any 240.

    For the rear, any 79 (or so) or newer bar will be interchangeable with any
    79 or newer 240. The later bars are designed to clear the exhaust which
    was routed under the axle after a few years. The earlier wagons
    especially often did not come with any bar and thus need a bit of drilling
    to fit a rear bar. Either way, it's usually no big deal.

    - alex
     
    Alex Zepeda, Jul 2, 2003
    #6
  7. MonkeyMan

    MonkeyMan Guest

    Great!

    If they are still in the pull yard, I'll upgrade the 244DL.

    Yippee!
     
    MonkeyMan, Jul 3, 2003
    #7
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.