You will have to take off the top trim panel running along the roof line and
cut out sections on both sides (there are markings on the on the back of the
panels). Behind the panels are bolt holes for the dog guard mountings.
Just plain logic is required to orientate them correctly. The plastic blocs
which screw into the seat backs are a little more difficult to site. With
the seats in the up position, clip the mountings onto the dog guard then
mark their position on the back of the seats to site the self tapping
screws, doing it this way will ensure that the guard is tight when down and
not rattle about making noise.
Ken
Stephen David Buchan said:
Just bought second hand dog guard with a bag of bits to fit it. Anyone out
there know the correct brackets to use and the orientation they should be
installed.
Thanks
S B
----== Posted via Newsgroups.com - Usenet Access to over 100,000 Newsgroups ==----
Get Anonymous, Uncensored, Access to West and East Coast Server Farms!
----== Highest Retention and Completion Rates!
HTTP://WWW.NEWSGROUPS.COM ==----
