F Murtz said:How do you remove the ignition switch mechanism?
It seems to me that you would get the oxy cutter out and start at the
boot,(aus) trunk,(American) and cut off everything that does not look
like the ignition switch till you get at it.
The Column Lock or the Starter Switch ??How do you remove the ignition switch mechanism?
It seems to me that you would get the oxy cutter out and start at the
boot,(aus) trunk,(American) and cut off everything that does not look
like the ignition switch till you get at it.
Just the starter switch, although if the whole contraption is removableGlennK said:The Column Lock or the Starter Switch ??
How do you remove the ignition switch mechanism?
Mr. V said:
F said:I did read that before asking the question but can not find little pin
to push and in any case there is no room above to get at if it exists.
Is this pin one inch from front of cylinder or back?
I did see a pin on left between cylinder and column but it wont move.
This description only would get cylinder out anyway, not switch
mechanism. My problem seems insurmountable so far.