I ran the on-board diagnostics today. The eletrical side came up "no
fault detected," but I got three codes on the fuel side:
3-1-4 Camshaft position sensor signal absent or faulty;
2-1-4 RPM sensor signal absent; and finally
3-2-4 ?? This one isn't listed in the Haynes manual. I may have read
it wrong, but I cleared the codes already. I guess the next time it
freaks out I'll check it again.
If something else were going wrong, could it trigger these codes? Or
should I go ahead and replace the Cam and RPM sensors? Any suggestions
where to look for these parts?
Thank you all so much!
Sam
