960 driveshaft

[shawnews]

My 960 have had some noise during acceleration from stand still and also
some vibration driving more than 100k/h. I replaced the centre support and
the bearing in the driveshaft, but there is not much change. I check again
the driveshaft again and I noticed that the U-joints are not align the same
way as the book for 740 specified.
I don't have book for 960. Should the alignment be the same for 960 as for
740 driveshaft?

 

[Mike F]

My 960 have had some noise during acceleration from stand still and also
some vibration driving more than 100k/h. I replaced the centre support and
the bearing in the driveshaft, but there is not much change. I check again
the driveshaft again and I noticed that the U-joints are not align the same
way as the book for 740 specified.
I don't have book for 960. Should the alignment be the same for 960 as for
740 driveshaft?

http://www.brickboard.com/FAQ/700-900/Driveline.htm

--
Mike F.
Thornhill (near Toronto), Ont.

Replace tt with t (twice!) and remove parentheses to email me directly.
(But I check the newsgroup more often than this email address.)