Flame trap oil leak

Discussion in 'General Motoring' started by John von Colditz, Apr 3, 2009.

  1. Car is a 1988 245 with 317,000 miles. I recently noticed oil running
    down the sides of the tube the flame trap is in. I replaced the flame
    trap, and no change. I have checked all of the vaccum lines, and
    replaced any that looked bad. I am still leaking oil. Suggestions?
     
    John von Colditz, Apr 3, 2009
    #1
  2. John von Colditz

    James Sweet Guest


    You might inspect or try cleaning out the oil separator box the flame
    trap connects to. At that mileage it's possible you have a lot of blowby
    causing more oil vapor in the crankcase than the separator can deal with.
     
    James Sweet, Apr 6, 2009
    #2
  3. James Sweet presented the following explanation :
    Thanks, James! I'll check it out!
     
    John von Colditz, Apr 6, 2009
    #3
  4. Take it off the" flame trap" and clean it out its causing back pressure
    forcing the oil out .Obviously your not using synthetic oil as Syn oil
    doesn't gum up .
     
    Jon Robertson, May 4, 2009
    #4
  5. Jon Robertson pretended :
    Actually, I've been using synthetic oil in it since about 2000...
     
    John von Colditz, May 4, 2009
    #5
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.