Installing a TAC in a 240

  • Thread starter Thread starter jsegura525
  • Start date Start date
J

jsegura525

Can this be installed in a automatic and/or a five speed?
Thanks,
JR
 
Can this be installed in a automatic and/or a five speed?
_____
Yes. There are two different form factors: 1) in main cluster (about 3
inch diameter), 2) in accessory cluster (2 inch diameter). Signal comes
from ignition coil. Can't remember which terminal. Check schematic in
Haynes book(s). The petrol powered 240 usually is pre-wired for a
tachometer. Should be red/white wire with female spade connector
somewhere in dash area. If you have a diesel powered 240, the signal
for the tachometer is derived from the alternator. The diesel's
tachometer calibration is different and cannot be used in a petrol
powered car.
 
Back
Top