need help (tips/hints) for replacing S70 Blower Motor

  • Thread starter Thread starter Ping Luo
  • Start date Start date
P

Ping Luo

I'm going to replace the Blower Motor myself in the next few weeks. Any
suggestions or guidance would be very much appreciated.

Thanks.

-ping
 
Ping said:
I'm going to replace the Blower Motor myself in the next few weeks. Any
suggestions or guidance would be very much appreciated.

Thanks.

-ping

It's pretty easy. You need to remove the glovebox, panel over the
passenger's feet and knee bolster if fitted. Then it's right in front
of you.
 
Make sure you don't just need to replace the "blower resistor"- about
$75 online and located on the bottom of the passenger side duct
work-follow the wires back from the blower motor- If you can run the
motor with 12v to the wires direct to the motor, it could be this
resistor unit. Held in by only two screws, it has a large black finned
heatsink built into it.
 
Ping Luo said:
I'm going to replace the Blower Motor myself in the next few weeks. Any
suggestions or guidance would be very much appreciated.

Thanks.

-ping

Guidance on how to do a blow job!?

Sorry, I could not resist that bad one. Its friday... :->

The Hayes book on Volvo x70 would suffice I think.
Good sites with 850/x70 maintenance tips:
http://www.volvospeed.com/maintence.htm
http://kinovolvo.velez.ws/

And then there is of course the expensive but quite good Volvo service
manual for x70

/Patrik
 

Members online

No members online now.

Trending content

Forum statistics

Threads
12,150
Messages
53,040
Members
2,182
Latest member
LWM
Back
Top