C
Clive Turnbull
Anyone know if the bumper/fender has to be removed to replace headlight
lens on 2001 V40 Thanks in anticipation
Clive Turnbull
Cheshire
UK
lens on 2001 V40 Thanks in anticipation
Clive Turnbull
Cheshire
UK
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
M
Martijn
Clive,
Just replaced mine 2 wekkes ago.
Remove screws of inside wheel covers, 2 scews on both sides.
Remove headlight washers if any.
Reach the plasic locks and push them from behin the front bumper. The enrire
bumper should be able to move a few inches towards you, bearly enough to
replace the head light.
Cheers,
Martijn
Just replaced mine 2 wekkes ago.
Remove screws of inside wheel covers, 2 scews on both sides.
Remove headlight washers if any.
Reach the plasic locks and push them from behin the front bumper. The enrire
bumper should be able to move a few inches towards you, bearly enough to
replace the head light.
Cheers,
Martijn
A
Arnoud Helmantel
Martijn said:Clive,
Just replaced mine 2 wekkes ago.
Remove screws of inside wheel covers, 2 scews on both sides.
Remove headlight washers if any.
Reach the plasic locks and push them from behin the front bumper. The enrire
bumper should be able to move a few inches towards you, bearly enough to
replace the head light.
Cheers,
Martijn
Here is part of my not-yet-finished how-to page that describes the steps
I took to get the headlights out of my MY99 V40. I haven't taken a close
up look at the phase2 bumper, but this might help:
http://www.helmantel.com/volvov40/headlights_howto.html
(there is NO page 2 yet)
greetings,
Arnoud
C
Clive Turnbull
Clive,
Just replaced mine 2 wekkes ago.
Remove screws of inside wheel covers, 2 scews on both sides.
Remove headlight washers if any.
Reach the plasic locks and push them from behin the front bumper. The
enrire bumper should be able to move a few inches towards you, bearly
enough to replace the head light.
Cheers,
Martijn
Thanks to both of you, I have printed Arnouds instructions so I am well
prepared for a try tomorrow. The one I am doing is RHD but I am sure
that will make little difference. Will post my progress. Cheers
Clive
C
Clive Turnbull
Here is part of my not-yet-finished how-to page that describes the
steps I took to get the headlights out of my MY99 V40. I haven't taken
a close up look at the phase2 bumper, but this might help:
http://www.helmantel.com/volvov40/headlights_howto.html
(there is NO page 2 yet)
greetings,
Arnoud
Managed this today without any problem! Thank you both once again your
input saved me a lot of time and effort Regards
Clive
Trending content
-
S
-
B
-
A
-
J