where did the vac hose go on b21ft?

Discussion in 'General Motoring' started by John Roden, Dec 27, 2003.

  1. John Roden

    John Roden Guest

    I realize this is a (very)dumb question, but an hour of looking and
    consulting Bently has not solved it, so here goes:

    I have a 83 245 turbo b21ft. Just replaced idle air control. I have a
    missing vac hose and cannot find the hose anywhere, it used to attach just
    upstream from the cold start injector, right next to where the one hose to
    the idle air control goes. It would face toward the rear of the engine. It
    must be a vacuum hose and appears to be quite large, maybe a half inch,
    about same size as idle air control.

    I've been under there for an hour looking, anyone know what the other end of
    this missing hose is connected to?

    Thanks in advance!
    John Roden, Dec 27, 2003
    1. Advertisements

  2. John Roden

    John Roden Guest

    Never mind, i was trying to attach the hose to the air motor to the
    casting boss on the throttle body, whoops!
    John Roden, Dec 28, 2003
    1. Advertisements

  3. John Roden

    James Sweet Guest

    Heh I did the same thing!
    James Sweet, Dec 30, 2003
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.