Pulling the Turbo Pipe on an 850 GLT

  • Thread starter Thread starter polara
  • Start date Start date
P

polara

On a 97 GLT turbo, I need to replace the plugs, wires, cap and rotor.
It looks like it would be a lot easier to do the job if I pull the
large, curved turbo pipe going over the top of the engine. Are there
any precautions to take when pulling this pipe? Is it sealed in any
way or can I just loosen the clamps and move it out of the way as
needed? Thanks.
 
polara said:
On a 97 GLT turbo, I need to replace the plugs, wires, cap and rotor.
It looks like it would be a lot easier to do the job if I pull the
large, curved turbo pipe going over the top of the engine. Are there
any precautions to take when pulling this pipe? Is it sealed in any
way or can I just loosen the clamps and move it out of the way as
needed? Thanks.
Click to expand...


Just loosen the clamps and remove it. Note that there may be a few drips of
oil in it, so have a couple paper towells ready.
 
You must log in or register to reply here.
Back
Top