Scantech parts/Tie Rod Assembly

Discussion in 'General Motoring' started by Allan, Nov 2, 2006.

  1. Allan

    Allan Guest

    Hi folks... I need to buy a Tie Rod Assembly for my 240. Just
    wondering - are scantech parts good quality?

    Thanks for reading...

    Allan
     
    Allan, Nov 2, 2006
    #1
  2. Allan

    Allan Guest

    On Fri, 03 Nov 2006 09:16:35 +1100, Allan <>
    wrote:

    Also, while I think of it... Does anyone know if the threads are the
    same on different brands? In other words - would a nut from a genuine
    Volvo Tie Rod Assembly fit the thread of the Scantech one?
     
    Allan, Nov 2, 2006
    #2
  3. Allan

    Michael Pardee Guest

    Dunno about the quality of Scantech, but the big thing to watch for is the
    mfr of the rack. ZF tie rods and cam gear tie rods are not interchangeable
    at all.

    Mike
     
    Michael Pardee, Nov 3, 2006
    #3
  4. Allan

    John Horner Guest

    I'm not a fan of Scantech parts personally.

    For tie rod ends and assemblies you can often find TRW, Moog or Meyle
    aftermarket parts. Any of those would be my preference over Scantech.

    You can check several sources for these:

    www.autohausaz.com
    www.eeuroparts.com
    www.rockauto.com
    www.discountautoparts.com


    John
     
    John Horner, Nov 3, 2006
    #4
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Tie Rod

  2. tie rod and sway bar replacement

  3. 2 Questions: Tie Rod and Engine Flush

  4. Replacing tie-rod ends on one side...

  5. Tie rods and wheel bearings

  6. ball joint - tie rod ends

  7. Tie-rod / Ball Joint question

  8. Ball joint and tie rod ends stuck ('93 850)

Loading...