Can't find transmission leak (part deux)

  • Thread starter Thread starter Jamie
  • Start date Start date
J

Jamie

Follow up, 1985 245 with tranny fluid leaking after overfill, then
very minor leak afterwards.

I pulled off the speedo gear from the rear of the tranny and found a
partially broken sprocket, a bad main O-ring and deteriorated thread
tape (if any).

I have a photo, I hope this will be the source of my leak.

Question:
At the base of the sprocket - does an o-ring go there? I see where
there is 1 main o-ring around the middle of the sensor body, 1 rubber
cap that fits into the tube going to the speedo? Did I miss any? How
many total?

THanks!

http://www.flickr.com/photo_zoom.gne?id=432465148&size=o


Jamie
 
Follow up, 1985 245 with tranny fluid leaking after overfill, then
very minor leak afterwards.

I pulled off the speedo gear from the rear of the tranny and found a
partially broken sprocket, a bad main O-ring and deteriorated thread
tape (if any).

I have a photo, I hope this will be the source of my leak.

Question:
At the base of the sprocket - does an o-ring go there? I see where
there is 1 main o-ring around the middle of the sensor body, 1 rubber
cap that fits into the tube going to the speedo? Did I miss any? How
many total?

THanks!

http://www.flickr.com/photo_zoom.gne?id=432465148&size=o

Jamie

I went to the mechanic shop for an O-ring and the guy thinks it isn't
the O-ring, but the cap that seals inside of the housing where the
speedo cable screws in. He says it got hard. So I used some form-a-
gasket to see if I can assist the seal until I replace the part.

jb
 
Follow up, 1985 245 with tranny fluid leaking after overfill, then
very minor leak afterwards.

I pulled off the speedo gear from the rear of the tranny and found a
partially broken sprocket, a bad main O-ring and deteriorated thread
tape (if any).

I have a photo, I hope this will be the source of my leak.

Question:
At the base of the sprocket - does an o-ring go there? I see where
there is 1 main o-ring around the middle of the sensor body, 1 rubber
cap that fits into the tube going to the speedo? Did I miss any? How
many total?

THanks!

http://www.flickr.com/photo_zoom.gne?id=432465148&size=o

Jamie

Looking at IPD (I can't find it at FCP), it seems to be called a
Speedo Cable Drive Seal. $2.50. I think I'll get an O-ring to boot and
see what happens.
 


Write your reply...

Members online

No members online now.

Trending content

Forum statistics

Threads
12,151
Messages
53,041
Members
2,183
Latest member
wholenewmom
Back
Top